Dialogic 4000 SERIES Manual de usuario descargar pdf (Pagina 70)

Dialogic

4000 Media Gateway Series Reference Guide

Page 70

Direct Routing between Two SIP Peers

If you choose to route all calls from the PSTN to the same SIP peer, and calls from that SIP peer to the PSTN,

configure the parameters as follows. For this configuration, no address rewriting is done:

1. Under SIP Peers, create one SIP peer with the necessary settings, and make sure that the option Default

peer for received SIP calls is enabled. Confirm with OK.

2. Under SIP Peers, create the other SIP peer with the necessary settings. Confirm with OK.

3. Under Routing, create Route 1 and do the following:

• Select the SIP Peer configured in Step 1 as a source peer.

• Select the SIP peer configured in Step 2 as a Master destination.

• Set the Number format field to Unchanged.

• Confirm with OK.

4. Under Routing, create Route 2 and do the following:

• Select the SIP peer configured in Step 2 as a source peer.

• Select the SIP peer configured in Step 1 as a Master destination.

•Set the Number format field to Unchanged.

• Confirm with OK.

5. Save the configuration in the main configuration interface.

Connecting Two SIP Peers to Two PSTN Interfaces Exclusively

If you choose to connect two SIP peers to two PSTN interfaces, so that each SIP peer can use one interface

exclusively, then carry out the following configuration steps. The procedure is similar if you need to configure

more PSTN interfaces, e.g., three PSTN interfaces to three SIP peers.

1. Under PSTN Interfaces, enable and configure the two PSTN interfaces. Confirm with OK.

2. Under SIP Peers, create both SIP peers and make sure the entry in Domain exactly matches the domain

used by the SIP peer in its SIP address for outgoing calls. Do not enable the option Default peer for

received SIP calls for any of these peers. Confirm with OK.

3. Under Routing, create Route 1 and do the following:

• Enable the first PSTN interface as a source peer.

• Enable the first SIP peer configured in Step 2 as a Master destination.

• Confirm with OK.

4. Under Routing, create Route 2. Then, repeat Step 3 for the second PSTN interface and the second SIP peer.

5. Under Routing, create Route 3 and do the following:

• Enable the first SIP peer configured in Step 2 as a source peer.

• Enable the first PSTN interface as a Master destination.

• Confirm with OK.

6. Under Routing, create Route 4. Then, repeat Step 5 for the second PSTN interface and the second SIP peer.

7. Save the configuration in the main configuration interface.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 167 168

Sin comentarios

Dialogic 4000 SERIES Manual de usuario Pagina 70