Dialogic 4000 SERIES Manual de usuario descargar pdf (Pagina 60)

Dialogic

4000 Media Gateway Series Reference Guide

Page 60

To configure the settings for each user that should register at the same registrar server, click Add and configure

the following parameters:

Logging and Diagnostics

You can configure the following parameters shown in Logging and Diagnostics section:

URI scheme: This option is only available if you selected TLS as Registrar protocol.

Calls are transmitted via various proxy servers. Some of them do not transmit the calls as

encrypted calls. If you select SIP (default), you allow calls to be transmitted via such proxy

servers.

To make sure that a call is sent encrypted to the proxy of the remote side, select SIPS (secure

SIP). If a call is routed via a proxy server that is not able to route the call encrypted, it rejects

the call and the call is send to another proxy until it can be transmitted.

Own display

name:

Enter the name that should be displayed at the registrar server.

URI scheme: Select either SIP (default) or SIPS as URI scheme.

User name: Enter the name or number that Diva SIPcontrol uses to register at the registrar server.

Domain: Enter the domain name of the registrar server.

Protocol: Select UDP if you register as an e-phone gateway.

Re-register time: Enter the re-register time in seconds. This is the time for which the registration to the registrar

server remains valid. After this time has elapsed, the SIP stack service would need to

re-register to be available again. The default value is 3600 seconds.

Auth user name: Enter a user name for authentication at the registrar server.

Password: Enter your password for authentication at the registrar server.

and you want Diva SIPcontrol to function as a gateway for e-phone.

Event Log Level: A computer with Diva SIPcontrol installed can write different types of events into the System Event

Log. The details for each event log are described in Event

Logging on page 89.

Debug Level: The debug level setting can be used for debugging and tracing purposes. During normal operation,

it should be set to Off to lessen the effect on system performance.

XML

configuration

file:

Shows the configuration in raw format. This option is used only by Dialogic Support.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 167 168

Sin comentarios

Dialogic 4000 SERIES Manual de usuario Pagina 60