Dialogic DSI SS7MD Manual de usuario descargar pdf (Pagina 86)

Chapter 6 Command Definitions

6.7 IP Commands

The IP commands include:

• IPEPS - Set Ethernet Port Configuration

• IPEPP - Display Ethernet Port Configuration

• IPGWI - Internet Protocol Gateway Initiate

• IPGWE - Internet Protocol Gateway End

• IPGWP - Internet Protocol Gateway Print

6.7.1 IPEPS – Set Ethernet Port Configuration

Synopsis

This command is used to configure Ethernet ports.

The SGW supports resilient IP connectivity when the user configures a team of two ports in an active/

standby role. Three IP bonding teams can be created from the six ethernet ports available. A bonding team,

assigned a single IP address, consists of a primary (active) port and a secondary (standby) port. The

secondary port IP address should be set to one of the following values:

• STANDBY1 - The configured IP address acts as the standby port in a team with ETH1.

• STANDBY2 - The configured IP address acts as the standby port in a team with ETH2.

• STANDBY3 - The configured IP address acts as the standby port in a team with ETH3.

• STANDBY4 - The configured IP address acts as the standby port in a team with ETH4.

• STANDBY5 - The configured IP address acts as the standby port in a team with ETH5.

• STANDBY6 - The configured IP address acts as the standby port in a team with ETH6.

Syntax

IPEPS:ETH=, {[SPEED=,] [IPADDR=,][SUBNET=,] [SCTP=]};

Prerequisites

None.

Limitations

Up to 2 IP ports configured with an IP address may be associated with SCTP.

Attributes

CONFIG.

Examples

IPEPS:ETH=1,SPEED=100;

IPEPS:ETH=2,IPADDR=123.124.125.126,SCTP=Y;

IPEPS:ETH=3,IPADDR=100.1.1.10,SUBNET=255.255.1.1;

IPEPS:ETH=4,IPADDR=STANDBY2;

The SCTP parameter indicates that the port can be used for SCTP communication.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 175 176

Sin comentarios

Dialogic DSI SS7MD Manual de usuario Pagina 86