Dialogic DSI SS7MD Manual de usuario descargar pdf (Pagina 62)

Chapter 6 Command Definitions

6.5.11 CNPCC – Configuration PCM Change

Synopsis

This command allows changes to the configuration of a PCM.

Syntax

CNPCC:PCM=,{[PCMTYPE=,]|[SYNCPRI=,][FF=,][LC=,][IDLE=][BM=][BUILDOUT=,]};

Prerequisites

• The PCM has already been initiated.

• For a PCMTYPE of E1, the LC can be set to HDB3 and the FF can be set to G704, CRC4, CRC4C or

CRC4G706.

• For a PCMTYPE of T1, the LC can be set to AMI or B8ZS and the FF can be set to SF, ESF or CRC6.

• An FF of CRC4G706 can only be set on a Dialogic

DSI SS7HDP Network Interface Board.

• The frame format (FF) value cannot be changed to or from UNS using this command - use CNPCI.

• The BUILDOUT parameter can only have a value of 0 for E1 and a value of 1 for T1s on boards of a type

other than SS7HDP.

Attributes

CONFIG

Examples

CNPCC:PCM=1-1,SYNCPRI=3;

6.5.12 CNPCE – Configuration PCM End

Synopsis

This command ends the configuration of a PCM such that it is unavailable for voice or signaling.

Syntax

CNPCE:PCM=;

Prerequisites

• No timeslot on the PCM has been assigned to voice, signaling monitoring or cross connections.

• The board on which the PCM exists has been blocked.

Attributes

CONFIG

Examples

CNPCE:PCM=1-1;

6.5.13 CNPCP – Configuration PCM Print

Synopsis

This command gives a printout of all the configured PCMs.

Syntax

CNPCP;

Prerequisites

None

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 175 176

Sin comentarios

Dialogic DSI SS7MD Manual de usuario Pagina 62