Dialogic DSI SS7MD Manual de usuario descargar pdf (Pagina 65)

Dialogic

DSI Signaling Server SGW Mode User Manual Issue 5

6.5.18 CNSMC – Change SNMP Manager Configuration

Synopsis

This command allows the administrator to alter an SNMP manager's configuration. The parameters and the

associated values are as per the CNSMI command.

Syntax

CNSMC:MNGR={,IPADDR=|,TFORMAT=|,PORT=|,TCOM=|,USER=|,ENGINE=|,LABEL=};

Prerequisites

The DSMI-based SNMP agent must be enabled.

The manager must already have been defined with the CNSMI command.

If an SNMP v3 user is specified, the user must already be defined.

Attributes

CONFIG

Examples

CNSMC:MNGR=1,IPADDR=192.168.220.222;

6.5.19 CNSME – End SNMP Manager Configuration

Synopsis

This command removes an SNMP manager definition from the list of configured SNMP managers. The

command takes a single parameter, MNGR, which identifies the particular manage to remove.

Syntax

CNSME:MNGR=;

Prerequisites

The DSMI-based SNMP agent must be enabled.

The manager must already have been defined with the CNSMI command.

Attributes

CONFIG

Examples

CNSME:MNGR=1;

6.5.20 CNSMI – Set SNMP Manager Configuration

Synopsis

This command allows the administrator to define up to 32 TRAP destinations (i.e. remote SNMP manager

stations). Each manager is defined by its IP address (IPADDR). Additionally, the type of TRAP to be

dispatched to the SNMP manager is specified with the TFORMAT parameter. The following values are

supported:

1 An SNMP v1 TRAP is sent

2 An SNMP v2 TRAP is sent

3 An SNMP v2 INFORM is sent

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 175 176

Sin comentarios

Dialogic DSI SS7MD Manual de usuario Pagina 65