Dialogic DSI SS7MD Manual de usuario descargar pdf (Pagina 109)

109

Dialogic

DSI Signaling Server SGW Mode User Manual Issue 5

6.12.2 SGDPC – Signaling Gateway Destination Point Change

Synopsis

This command changes parameters on the Signaling Gateway destination point.

Syntax

SGDPC:DEST=,[RTPRI=,][RAS=,][LABEL=,];

Prerequisites

• The destination point has already been initiated.

• If an RAS is specified, it must serve only one destination.

• If an RAS is specified, it must be initialized.

• RTPRI cannot be set to NONE if an RAS is not present.

• NONE is the only value allowed for RTPRI if RAS is present.

• If an RAS is specified, there cannot be any routing key in the system with a destination to this RAS, not

having or not matching the NC/DPC parameters with the RAS NC/DPC.

Attributes

CONFIG

Examples

SGDPC:DEST=1, RAS=1;

6.12.3 SGDPE – Signaling Gateway Destination Point End

Synopsis

This command ends a Signaling Gateway destination point.

Syntax

SGDPE:DEST=;

Prerequisites

• The destination ID has already been initiated.

• The destination ID is not used elsewhere in the system.

Attributes

CONFIG

Examples

SGDPE:DEST=1;

6.12.4 SGDPP – Signaling Gateway Destination Point Print

Synopsis

This command prints the configuration of routing parameters on a SS7 Signaling Gateway.

Syntax

SGDPP:[DEST=];

Prerequisites

• The destination ID has already been initiated.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 175 176

Sin comentarios

Dialogic DSI SS7MD Manual de usuario Pagina 109