Dialogic 4000 Series SU4.1 Manual de usuario descargar pdf (Pagina 53)

Dialogic® Diva® SIPcontrol™ Configuration

Use session

timer:

Activates session monitoring via SIP session timers using the time-out

values given here. Refer to RFC 4028 for details.

Interval:

If Use session timer is enabled, you can set a time-out in seconds

until a call is considered to be aborted. Refreshes are normally

performed after the first half of the interval has elapsed. The minimum

value is 90 seconds. The default value is 600 seconds.

Minimum

session

expires:

If Use session timer is enabled, you can set a time in seconds

between two session refresh messages that Diva SIPcontrol will accept.

The minimum value is 90 seconds.

Address Normalization

You can configure the following parameters in the Address Normalization section when

you define or modify a SIP Peer:

Dialplan:

Select the local dialplan to be used by the dialplan module of Diva

SIPcontrol. Configure the local dialplan as described in Dialplans,

before you select it here.

The dialplan selected here applies only to outgoing calls.

Number

format

(outbound):

This parameter determines the shortest format allowed that is sent in

calls to this SIP peer. You can modify this parameter only if you

selected a dialplan from the drop down menu. The following options

are available:

Unchanged: The number signaled in the SIP message will be used

unchanged for dialing.

International number: The number is always converted to an

international number, including country and area code.

National number: The number is converted to a national number

unless it is an international number with a different country code.

Extension: The number is reduced as much as possible. An internal

number is reduced to its extension only.

For more information about number formats, see Number Modification

Using Address Maps.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 225 226

Sin comentarios

Dialogic 4000 Series SU4.1 Manual de usuario Pagina 53