Dialogic 4000 Series SU4.1 Manual de usuario descargar pdf (Pagina 34)

Dialogic 4000 Media Gateway Series SU4.1 Reference Guide

 In the Password section, enter the current and new passwords, and then retype

the new password. A password must be seven digits or longer, and the use of

non-alphanumeric characters for a password is discouraged.

 Click Change Password.

2. If necessary, open the port in the local firewall settings. To do this under Windows®

Vista, Windows

7, Windows Server

2008, or Windows 2008

R2, open the

command prompt with elevated rights.

 Enter the following command on a 64-bit operating system:

netsh advfirewall firewall add rule name="Diva Webserver" dir=in

action=allow program="%ProgramFiles% (x86)\

Diva Server\DivaWebConfig.exe" protocol=tcp

 Enter the following command on a 32-bit operating system:

netsh advfirewall firewall add rule name="Diva Webserver" dir=in

action=allow program="%ProgramFiles%\

Diva Server\DivaWebConfig.exe" protocol=tcp

You can now access the Diva SIPcontrol web interface on any of the IP addresses of the

computer where SIPcontrol is installed, and then you can configure the settings according to

your needs.

Dialogic® Diva® SIPcontrol™ Configuration Sections

Diva SIPcontrol configuration is divided into the following sections:

 PSTN Interfaces

 Network Interfaces

 SIP Peers

 Routing

 Security Profiles

 LDAP

 Dialplans

 Address Maps

 Cause Code Maps

 Codec Profiles

 Registrations

 Logging and Diagnostics

Configuration Tips and Hints

This section contains useful information about SIPcontrol configuration:

 Changes to the configuration will only take effect after you click Activate

Configuration at the bottom of each configuration page.

 The settings will be lost if you close the Diva SIPcontrol web interface without having

saved the configuration at the bottom of each configuration page.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 225 226

Sin comentarios

Dialogic 4000 Series SU4.1 Manual de usuario Pagina 34