Dialogic 4000 Series SU4.1 Manual de usuario descargar pdf (Pagina 47)

Dialogic® Diva® SIPcontrol™ Configuration

Name:

Enter a name for the SIP peer. A SIP peer is a specific endpoint to and

from which Diva SIPcontrol can establish calls.

Peer type:

SIPcontrol needs special workarounds to work properly with some SIP

peers, such as Microsoft

Exchange Server. If this is the case for your

configuration, select the specific SIP peer. If not, select Default.

Host:

Enter the host name or IP address of the peer. The name must be

resolvable by local name resolution. During the establishment of a call,

the host name is sent by this peer exactly as entered here, unless an

address map applies that converts the host name to a different format.

For more information about name resolution, see the Windows

documentation.

Port:

Displays the SIP port on which the remote peer is listening. The default

is 5060, which is the standard port for SIP.

IP protocol:

Select the IP protocol to be used for calls to this peer. Calls from this

peer are accepted with all protocols and on all ports/addresses

configured in Network Interfaces.

If you selected:

 MS Exchange 2007 or MS OCS 2007/2007 R2 - Mediation

Server as the Peer type, set the protocol to TCP.

 MS Lync 2010 - Mediation Server as the Peer type, set the

protocol to TCP or TLS.

 e-phone, as the Peer type, set the protocol to UDP.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 225 226

Sin comentarios

Dialogic 4000 Series SU4.1 Manual de usuario Pagina 47