Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Manual de usuario descargar pdf (Pagina 75)

In addition to this, you can configure XMediusFAX to provide notifications in the usual Exchange UM form

(2007) when a fax is routed by an Exchange UM Rule: see Configuring the Mail Notification Profile for UM

Integration on page 65.

Configuring the Mail Notification Profile for UM Integration

Note: This configuration applies only when integrating Microsoft Exchange UM since version 2010.

To receive fax notifications by email in the usual Exchange UM form (2007), all users indicated by the UM

module must:

• Exist in a directory known by the Fax Server (see the Directories Integration section of the XMediusFAX

Administration Guide for more details).

• Have their Profile set to use a Mail Notification Profile configured for Exchange UM integration, as described

in the following procedure.

For more details on Profiles and Mail Notification Profiles, see the XMediusFAX Administration Guide.

Note: The following configuration is useful only if you have added an Exchange UM Rule to the Incoming

Routing Table of your site (see Configuring the Incoming Routing Table of a Site for UM Routing on page

64).

To configure XMediusFAX to provide notifications in the usual Exchange UM form when a fax is routed by

an Exchange UM Rule:

1. In the XMediusFAX administration interface, access the Configuration ➤ Mail Notification Profiles node

of your site.

2. Access the properties of the concerned Mail Notification Profile or create a new one, depending on your

needs (see the Mail Notification Profiles section of the XMediusFAX Administration Guide for more details).

3. In the Exchange Integration section of the Notification Options tab, select Generate Exchange UM

Message Format for Inbound Faxes Redirected from Exchange UM.

Note: You can choose to configure this section differently if you wish to customize a bit more the

mail notifications management on this profile. To know the behaviors you can expect depending on

the possible combinations of the two checkboxes in the Exchange Integration section, see Outlook

Forms vs Exchange UM Format: Mail Notification Behaviors on page 66.

4. Validate the configuration with OK.

Note: Using this feature (Generate Exchange UM Message Format for Inbound Faxes Redirected

from Exchange UM) requires the creation of a new Receive Connector with special permissions on

your Exchange Server (see the following step).

5. From the prompt of the Exchange Management Shell, create a new Receive Connector by executing the

following command:

New-ReceiveConnector -Name <ConnectorName> -Bindings "0.0.0.0:25"

-RemoteIPRanges <FaxServerIpAddress> -AuthMechanism ExternalAuthoritative

-PermissionGroups ExchangeServers,Partners

•

<ConnectorName> must be replaced by the name you wish to give to the connector.

•

<FaxServerIpAddress> must be replaced with the hostname(s) or IP address(es) of the host(s) where

the XMediusFAX SMTP Gateway is running.

Note: The permissions enabled for this connector are only the following ones:

• Authentication ➤ Externally Secured

• Permission Groups ➤ Exchange Servers

XMediusFAX | Installation and Maintenance Guide 65

Chapter 7 | Microsoft Exchange UM Integration

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 101 102

Comentarios a estos manuales

Sin comentarios

Dialogic Brooktrout TR1034 DID, Combo, & Loop Start Manual de usuario Pagina 75

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Dialogic Brooktrout TR1034 DID, Combo, & Loop Start