Dialogic SS7G2X Manual de usuario descargar pdf (Pagina 121)

121

Dialogic

SS7G2x Signaling Server SGW Mode User Manual Issue 4

6.13.11 SNSLC – SIGTRAN Signaling Link Change

Synopsis

This command changes parameters on a SIGTRAN link. A SIGTRAN link provides an SCTP association to an

adjacent SIGTRAN server.

If two IP addresses are specified, the first IP address is used until it proves unreliable in which case the

second is used.

An IP address of 0.0.0.0 indicates that the parameter is not configured.

When SECURE is set to Y, the SIGTRAN link does not come into service on unblocking if it receives messaging

from a peer that has an IP address not associated with the SIGTRAN link.

Note: Normal operation for M2PA would be to set both ends to client.

Syntax

SNSLC:SNLINK=,END=,[IPADDR=,][IPADDR2=,][HPORT=]

[PPORT=,][SRTX=,][LABEL=,][SECURE=,];

Prerequisites

• The SIGTRAN link has already been initiated and is blocked.

• The END can only be Client (C) or Server (S).

Attributes

CONFIG

Examples

SNSLC:SNLINK=1, PPORT=2905;

6.13.12 SNSLE – SIGTRAN Signaling Link End

Synopsis

This command ends the configuration of parameters on a SIGTRAN signaling link.

Syntax

SNSLE:SNLINK=;

Prerequisites

• The SIGTRAN link has already been initiated and is blocked.

• The SIGTRAN link cannot be ended if it is attached to an Application Server (AS).

• There cannot be any NC/NA mapping configured on the SNLINK.

• The SNLINK cannot be ended if it is associated with a C7LINK.

Attributes

CONFIG

Examples

SNSLE:SNLINK=1;

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 169 170

Sin comentarios

Dialogic SS7G2X Manual de usuario Pagina 121