Dialogic SS7G2X Manual de usuario descargar pdf (Pagina 110)

110

Chapter 6 Command Definitions

6.12.6 SGIRC – Signaling Gateway Incoming Route Change

Synopsis

This command changes the configuration of a Signaling Gateway incoming route.

For RKTAB/DEST, a value of “null” is supported. “null” indicates a wildcard value and means any value. “null”

is the default value for an RKTAB/DEST entry.

Note: The value “null” cannot be used for these parameters elsewhere in the system unless explicitly

specified in the command.

Syntax

SGOPC:IR=,[RKTAB=,][DEST=,][LABEL=];

Prerequisites

• The incoming route already exists.

• If specified, the destination index exists.

• The NC/DOMAIN combination has already been initiated.

• Either an RKTAB or DEST must exist.

Attributes

CONFIG

Examples

SGIRC:IR=1,DEST=5;

6.12.7 SGIRE – Signaling Gateway Incoming Route End

Synopsis

This command ends the configuration of a Signaling Gateway incoming route.

Syntax

SGIRE:IR=;

Prerequisites

• The incoming route already exists.

Attributes

CONFIG

Examples

SGIRE:IR=1;

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 169 170

Sin comentarios

Dialogic SS7G2X Manual de usuario Pagina 110