Dialogic SS7G2X Manual de usuario descargar pdf (Pagina 112)

112

Chapter 6 Command Definitions

6.12.9 SGRKI – Signaling Gateway Routing Key Initiate

Synopsis

This command initiates a routing key or partial routing key to determine a destination identifier. The

destination identifier is then used to select the outgoing destination. The Signaling Gateway compares the

routing keys with a data message in an attempt to find a data match. If a match is found, the destination

identifier is then used to select a route to an eventual destination.

The user can define a number of different tables of routing keys. In the routing model, the incoming route

identifies which routing table to use.

Apart from the routing key index and routing key table, the routing key elements are optional and can be

wildcarded with a null string.

A routing key is defined as a combination of NC//NI/SI/OPC/DPC/BCIC/RANGE.

For DPC, OPC, NI, SI, NC, BCIC and RANGE, a value of “null” is supported. “null” indicates a wildcard value

and means any value. “null” is the default value for a routing key entry.

Note: The value “null” cannot be used for these parameters elsewhere in the system unless explicitly

specified in the command.

Syntax

SGRKI:RKI=,RKTAB=,[NC=,][OPC=,][NI=,][SI=,][DPC=,][RANGE=,BCIC=,]DEST=;

Prerequisites

• The routing key ID has not already been specified.

• The routing key combination has not already been specified nor does it form a superset or subset of an

existing routing key.

Note: This check takes into account one or more routing elements marked as a wild card.

• The destination ID has already been initiated.

• If SI is set to SCCP, the BCIC/RANGE parameters cannot be specified.

• If one of BCIC/RANGE are specified, the other must be specified.

• For circuit related keys, the CIC ranges specified for an NC/OPC/NI/DPC combination must not overlap

existing ranges for that combination.

• If an OPC or DPC are specified, the NC cannot be wildcarded.

• BCIC cannot be negative.

• If the routing key has a destination to an AS, the NC/DPC parameters are required and must match with

the AS NC/DPC.

Attributes

CONFIG

Examples

SGRKI:RKI=1,RKTAB=,NC=1,OPC=55,DPC=33,DEST=1;

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 169 170

Sin comentarios

Dialogic SS7G2X Manual de usuario Pagina 112