Dialogic Diva Pro PC Manual de instalación descargar pdf (Pagina 12)

GFI FaxMaker

1 Installing fax devices |12

32-bit systems: Setup.exe remove_drv

64-bit systems: Setup64.exe remove_drv

3. When drivers are removed, run the following command:

32-bit systems: Setup.exe -clean

64-bit systems: Setup64.exe -clean

4. From the Control Panel Programs list, uninstall BladeWare.

5. Switch off the server.

6. Plug in the new Sangoma devices or spans following the instructions supplied with the hardware.

7. Start the server and re-install the drivers from the GFI FaxMaker Configuration Wizard. For more information, refer to

Installing Sangoma fax devices (page 9).

1.4.2 Advanced Sangoma Configuration

GFI FaxMaker includes a Sangoma Configuration Tool to manage and configure Sangoma device and span settings.

IMPORTANT NOTES

1. Use the Sangoma Configuration Tool only if you are experienced in advanced fax card configurations and when

troubleshooting issues with the assistance of GFISupport.

2. The Sangoma Configuration Tool stops the GFI FaxMaker Fax Service, stopping fax transmission.

Device/Span configuration

1. Open the GFI FaxMaker installation folder and run SangomaConfigUI.exe.

2. If the GFI FaxMaker Fax Service is started, click Stop service now to stop the service.

3. If loading the tool the first time and an ISDNcard is detected, choose your system's digital transmission format.

Contact your service provider to confirm the format used.

T1 is typically used in the USA, Canada and Japan

E1 is typically used in Europe.

4. The tool displays the list of devices and spans on the left side of the screen. Choose a device or span to configure and

change settings from the right pane.

5. When all settings are configured, click Applyand Save settings.

6. If the GFI FaxMaker Fax Service was stopped by the tool in the beginning, it is now automatically started.

Reset all settings to default

NOTE

This action is irreversible and all custom settings are permanently lost.

To reset all Sangoma devices' and spans' settings to default:

1. Open the GFI FaxMaker installation folder and run SangomaConfigUI.exe.

2. If the GFI FaxMaker Fax Service is started, click Stop service now to stop the service.

3. In the Sangoma Devices and Spans screen, click Options.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Sin comentarios

Dialogic Diva Pro PC Manual de instalación Pagina 12