Dialogic Diva Pro PC Manual de instalación descargar pdf (Pagina 11)

GFI FaxMaker

1 Installing fax devices |11

Screenshot 10: Selecting the Sangoma components to install

8. IMPORTANT: choose to install MSPSDKand do not install BladeWare Service or BladeWare Client SDK.

9. Click Install and click Finish to finalize installation.

10. Restart the system. On restart, the GFI FaxMaker Configuration Wizard loads automatically and the Sangoma Con

figuration Tool is started.

11. If an ISDNcard is detected, select the system's digital transmission format. T1 is used in the USA, Canada and Japan,

whilst E1 is used in Europe. Contact your service provider to confirm the format used.

12. Alist of Sangoma devices and spans is displayed. It is recommended that only experienced professionals configure

device settings. Typically no further configuration is required. Click Applyand Save to close the Sangoma Configuration

Tool.

13. Proceed with the GFI FaxMaker Configuration Wizard.

1.4.1 Modifying Sangoma fax devices

When adding new Sangoma devices/spans to a setup where Sangoma drivers are already installed, the drivers must be

uninstalled and re-installed.

NOTE

1. System restarts are required to uninstall old drivers and re-install updated drivers.

2. When installing Sangoma devices/spans the first time, refer to Installing Sangoma fax devices.

1. Open command prompt and change directory to the following Commetrex installation folder: ..\Com-

metrex\Sangoma\wanpipe\card\. This is typically found in the following locations:

32-bit systems: C:\Program Files\Commetrex\Sangoma\wanpipe\card\

64-bit systems: C:\Program Files (x86)\Commetrex\Sangoma\wanpipe\card\

2. Run the following command:

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Sin comentarios

Dialogic Diva Pro PC Manual de instalación Pagina 11