Configuring the Dialogic Media Gateway Configuring the Dialogic Media Gateway
4 Copyright © 2012 ADTRAN, Inc. 6UCSTN0088-4A
Configuring the Dialogic Media Gateway
The following configuration steps are required to configure the Dialogic media gateway for integration
with NetVanta UC Server:
1. Accessing the Media Gateway on page 4
2. Configuring the SIP Parameters on page 6
3. Configuring the Routing Tables on page 7
4. Configuring VoIP Media Settings on page 14
5. Configuring the Media Gateway for Specific PBX Integrations on page 15
Accessing the Media Gateway
There are two methods of configuration: serial interface or the Web interface using Hypertext Transfer
Protocol (HTTP). Detailed instructions can be found in the Dialogic 1000 and 2000 Media Gateway Series
Getting Started Guide shipped with your media gateway or from the Dialogic website. A summary is
provided for convenience.
• Serial Interface: Using the serial port, you can run the basic configuration and set the parameters for
both the media gateway and PBX. Refer to
Accessing and Performing the Initial Configuration for the
DMG1000 Series Using the Serial Interface on page 4 for the DMG1000 series or Accessing and
Performing the Initial Configuration for the DMG2000 Series using the Serial Interface on page 5 for
the DMG2000 series.
• Web configuration: The default IP address of the Dialogic media gateway is 10.12.13.74. To access
the configuration menus, configure a local computer with an IP address on the same subnet (for
example, 10.12.13.75) and, using a Web browser, navigate to http://10.12.13.74.
Accessing and Performing the Initial Configuration for the DMG1000 Series Using the
Serial Interface
To access and perform the initial configuration for the DMG1000 series using the serial interface, follow
these steps:
1. Connect the serial cable to the serial connector labeled Diagnostics on the back of the unit, and connect
the other end to the serial connector on your PC.
2. Using a terminal emulation program such as HyperTerminal, create a connection using the following
parameters:
• Baud rate: 38400
• Parity: None
• Data Bits: 8
• Stop Bits: 1
• Hardware Flow Control: Off
3. Select Connect.
(12 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales