Dialogic DMG1008DNI Manual de usuario descargar pdf (Pagina 9)

10 : 23 :

11 : 24 :

12 : 25 :

13 : 26 :

At End of Member List

Important notes about the above programming:

Page 1

• To change the type of hunting performed by this group, you can change the

Group Type

parameter. These settings can be changed between a uniform style of call distribution (round

robin) and a linear style.

• If desired, you can also activate queuing on the hunt group to allow a call to ring into the group

even if all the ports in the group are busy.

Page 2

• This is the page where you add each of the gateway ports that are going to be part of your

inbound hunt group. If required, you may add additional channels past the limits of this page.

Use the change coverage path or add coverage path command to configure a single coverage

path to act as a forwarding rule to be assigned to each subscriber.

change coverage path 20 Page 1 of 1

COVERAGE PATH

Coverage Path Number: 20

Hunt after Coverage? n

Next Path Number: Linkage

COVERAGE CRITERIA

Station/Group Status Inside Call Outside Call

Active? n n

Busy? y y

Don't Answer? y y Number of Rings: 4

All? n n

DND/SAC/Goto Cover? y y

COVERAGE POINTS

Terminate to Coverage Pts. with Bridged Appearances? n

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Sin comentarios

Dialogic DMG1008DNI Manual de usuario Pagina 9