Dialogic DMG1008DNI Manual de usuario descargar pdf (Pagina 7)

6: 18:

7: 19:

8: 20:

9: 21:

10: 22:

11: 23:

12: 24:

change station 575 Page 5 of 5

STATION

DISPLAY BUTTON ASSIGNMENTS

1: normal

Important notes about the above programming:

Page 1

• The station

Type is important. A beneficial configuration will have the gateway ports set up as

‘7434ND’ (note the ND at the end of the type).

• Because you are selecting a station type that has an option display module, and the gateway

requires that display to be present for integration data, you must set the Display Module option

to ‘

y’ and then set the Display Language to ‘english’.

Page 2

• For a channel that is going to be used for processing MWIs, you must set the

LWC Activation

parameter to ‘y’. This gives that specific port the ability to process MWI sets and clears.

• Because the Avaya PBX requires that you configure the station set with two call appearances (as

seen on the next page), if you are going to do transfers you must configure each port with the

Restrict Last Appearance parameter set to ‘y’. This will ensure that you always have the

second appearance in an idle state for doing transfers.

Page 3

• Because of a requirement of the Avaya PBX, you must configure each channel that is going to do

transfers with two call appearances. These two appearances must be on the first 2 buttons

(Buttons # 1 & 2) of the station.

• For a channel that will be used to process MWIs, you must administer both a

LWC-Store and a

LWC-Cancel key on the last two buttons (Buttons # 9 & 10) of the station set.

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Sin comentarios

Dialogic DMG1008DNI Manual de usuario Pagina 7