Dialogic SS7G21 Manual de usuario Pagina 43
- Pagina / 91
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
43
Dialogic
®
SS7G21 and SS7G22 Signaling Servers Hardware Manual Issue 7
Chapter 7: Warnings and Cautions
WARNING
QUALIFIED SERVICE TECHNICIAN OPERATIONS:
Only a qualified service technician is authorized to remove the Top Cover and to access
any of the components inside the product. Before removing the Top Cover, see
Section 10.1, “Safety: Before Removing the Top Cover” on page 59 and Chapter 7,
“Warnings and Cautions”.
WARNING
ANCHOR THE EQUIPMENT RACK:
The equipment rack must be anchored to an unmovable support to prevent it from
falling over when one or more products are extended in front of the rack on slides. You
must also consider the weight of any other device installed in the rack. A crush hazard
exists should the rack tilt forward which could cause serious injury.
Only use a screwdriver tip to push in lock tabs on rack slides. A pinch hazard exists if
fingers are used for this purpose.
WARNING
TELECOMMUNICATIONS NETWORK CONNECTION:
The telecommunication interfaces of this product are not intended for direct
connection to “outside plant” signal conductors (metallic). The product shall be
isolated, by channel banks or office repeaters, from any connections to network or
terminal equipment, that lie outside of the same building. The telecommunication
interface connections are considered to be, and meet the requirements of, SELV
circuits (not TNV). Refer also to any region specific regulatory requirements of network
connection in Chapter 4, “Regulatory Specifications and Declarations”.
Note that for some geographic regions, and subject to limitations, the T1/E1 ports of
Dialogic
®
SS7HDP boards in Dialogic
®
SS7G22 products may be connected to “outside
plant” signal conductors, and therefore become TNV-1 circuits. See Section 4.3.3,
“Telecommunications” on page 28 for more details.
- Dialogic 1
- SS7G21 and SS7G22 1
- Signaling Servers 1
- Contents 3
- Revision History 5
- Part 1: User’s Guide 6
- Chapter 2: Introduction 11
- Chapter 2 Introduction 12
- Declaration of Conformity 23
- 5.2 Front Panel 32
- 5.3 Back Panel 33
- Chapter 6: Interfaces 35
- DC Power Supply Module 52
- Terminal Block Connections 52
- Insulating 52
- AC power supply module shown 55
- ISA Edge 63
- Retainer 63
- Cable Tie 66
- 11.1 WARNING: English 69
- Warning: English (continued) 70
- 11.2 AVERTISSEMENTS: Français 71
- 11.3 WARNUNG: Deutsch 73
- Fortsetzung 73
- 11.4 AVVERTENZA: Italiano 75
- 11.5 ADVERTENCIA: Español 77
- Table 15 shows the Dialogic 79
- Table 17. Accessories 80
- Appendix A 83
- Glossary 87
Relacionado con productos y manuales para Redes Dialogic SS7G21
Redes Dialogic 3000 Manual de usuario
(32 paginas)
(32 paginas)
Redes Dialogic IPT10000C Manual de usuario
(2 paginas)
(2 paginas)
Redes Dialogic Mitel SX-2000 Manual de instrucciones
(20 paginas)
(20 paginas)
Redes Dialogic TX4000 PCI SS7 Especificaciones
(147 paginas)
(147 paginas)
Redes Dialogic Brooktrout TR1034 BRI Guía de usuario
(95 paginas)
(95 paginas)
Redes Dialogic DSI SS7MD Guía de instalación
(2 paginas)
(2 paginas)
Redes Dialogic IMG 1004 Especificaciones
(10 paginas)
(10 paginas)
Redes Dialogic DSI SS7MD Guía de usuario
(73 paginas)
(73 paginas)
Redes Dialogic Combo Guía de instalación
(2 paginas)
(2 paginas)
Redes Dialogic & Loop Start Guía de instalación
(2 paginas)
(2 paginas)
Redes Dialogic Mitel SX-2000 Manual de usuario
(8 paginas)
(8 paginas)
Redes Dialogic Diva ISDN PCI Guía de instalación
(168 paginas)
(168 paginas)
Sony SVP112190X podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Notatniki Sony SVP112190X.
Dostarczamy 1 pdf podręczników Sony SVP112190X do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentarios a estos manuales