Dialogic DMG2030DTI Manual de usuario descargar pdf (Pagina 6)

DMG 1000 Series Configuration - Serial Interface

1. Connect the serial cable to the serial connector on the back of the unit labeled diagnostics, and

connect the other end to the serial connector on your PC.

2. Using a terminal interface program such as HyperTerminal, create a connection using the

following parameters:

 Baud rate: 38400

 Parity: None

 Data Bits: 8

 Stop Bits: 1

 Hardware Flow Control: Off

3. Select connect.

4. Press the Enter key until the following prompt appears:

PIMG>

5. At the prompt, type pwd and press Enter.

6. When prompted, type the password for the admin user (the default is IpodAdmin) and press

Enter.

7. At the prompt, type quickcfg and press Enter.

8. You are prompted to enter the following parameters:

Client IP Address: Type the IP Address that you want to assign to the media gateway.

Client Subnet Mask: Type the subnet mask that you want to assign to the media gateway.

Default Network Address: Type the IP Address of the default network router.

Select Operating Mode: Type SIP.

PBX Type: Type the value that corresponds to your PBX.

9. Type Restart at the PIMG> prompt.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Sin comentarios

Dialogic DMG2030DTI Manual de usuario Pagina 6